OH MY FUCK
@f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme  @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme @f3arme

w/ @feardorian

GON' BE OK (prod.daln)

breakin bad prod. neonmaid + 2fayth

//
In radio communications, a receiver (radio receiver or simply radio) is an electronic device that receives radio waves and converts the information carried by them to a usable form. It is used with an antenna. The antenna intercepts radio waves (electromagnetic waves) and converts them to tiny alternating currents which are applied to the receiver, and the receiver extracts the desired information. The receiver uses electronic filters to separate the desired radio frequency signal from all the other signals picked up by the antenna, an electronic amplifier to increase the power of the signal for further processing, and finally recovers the desired information through demodulation.

The information produced by the receiver may be in the form of sound, images, or data.[1] A radio receiver may be a separate piece of electronic equipment, or an electronic circuit within another device. Radio receivers are very widely used in modern technology, as components of communications, broadcasting, remote control, and wireless networking systems. In consumer electronics, the terms radio and radio receiver are often used specifically for receivers designed to reproduce sound transmitted by radio broadcasting stations, historically the first mass-market commercial radio application.

AM and FM

Modulation is the process of adding information to a radio carrier wave. Two types of modulation are used in analog radio broadcasting systems; AM and FM.

In amplitude modulation (AM) the strength of the radio signal is varied by the audio signal. AM broadcasting is allowed in the AM broadcast bands which are between 148 and 283 kHz in the longwave range, and between 526 and 1706 kHz in the medium frequency (MF) range of the radio spectrum. AM broadcasting is also permitted in shortwave bands, between about 2.3 and 26 MHz, which are used for long distance international broadcasting.

In frequency modulation (FM) the frequency of the radio signal is varied slightly by the audio signal. FM broadcasting is permitted in the FM broadcast bands between about 65 and 108 MHz in the very high frequency (VHF) range. The exact frequency ranges vary somewhat in different countries.

FM stereo radio stations broadcast in stereophonic sound (stereo), transmitting two sound channels representing left and right microphones. A stereo receiver contains the additional circuits and parallel signal paths to reproduce the two separate channels. A monaural receiver, in contrast, only receives a single audio channel that is a combination (sum) of the left and right channels.[2][3][4] While AM stereo transmitters and receivers exist, they have not achieved the popularity of FM stereo.

Many radios, called "AM/FM" radios, are able to receive both AM and FM radio stations, and have a switch to select which band to receive.
Reception
The signal strength of radio waves decreases the farther they travel from the transmitter, so a radio station can only be received within a limited range of its transmitter. The range depends on the power of the transmitter,the sensitivity of the receiver, atmospheric and internal noise, as well as any geographical obstructions such as hills between transmitter and receiver. AM broadcast band radio waves travel as ground waves which follow the contour of the Earth, so AM radio stations can be reliably received at hundreds of miles distance. Due to their higher frequency, FM band radio signals cannot travel far beyond the visual horizon; limiting reception distance to about 40 miles (64 km), and can be blocked by hills between the transmitter and receiver. However FM radio is less susceptible to interference from radio noise (RFI, sferics, static) and has higher fidelity; better frequency response and less audio distortion, than AM. So in many countries serious music is only broadcast by FM stations, and AM stations specialize in radio news, talk radio, and sports.

ASDFGHJKL

bad year

unwinddd

andras - it me

can you spend 20k w/ me

pin on I think I just died

GODS CRAZY WISH WAS TAKEN FOR GRANTED

ＬＡＹＥＲ １１ ― IṈҒ4ṈI7Ɏ WΓLDDD [𝒞𝒴𝐵𝐸𝑅𝐼𝒜 𝑀𝐼𝒳] [ᔑᕋᒐ ꙆᙁᒍᙓᙅƮᙓᙃ] 𝐋𝐄𝐀𝐊𝐄𝐃

unwinddd

WRIS ™

Recent comments

lone

VØLT

o̶xela. 🐂

lol

Related tracks