Instructions:
Just plug the headphone, speaker, or audio interface output jack from your computer into the Korg Poly 61's "From Tape." Switch "Enable Tape" to "Enable," push the "Load" button, and play the preset data. If the data was successfully loaded the display should say "GOOD."

Patch Data Sound For Korg Poly - 61

plug "audio out" from your headphone, speaker, or audio interface into the korg poly 800 "tape in" using a standard audio cable. setup poly 800 to receive tape mode. Press the "load" button, and play the audio file from the computer into the poly 800. if you get an error, try adjusting the volume. If the data was successfully loaded the display will say "GOOD. "This will erase the entire patch memory and replace it with the factory patches. Make sure to backup your patches before resetting the patches to the factory preset.

Patch Data Sound For Korg Poly - 800

Get the Soundcloud file ready to play, and connect a cable from your audio output from your computer to the CASSETTE LOAD jack on the 106. Select the bank group you want to load (A or B), hit the LOAD button and then start the playback.

Akai AX80 (Rev K) Factory Preset Data Cassette Tape

ColoradoSynthDoctor

Recent comments

RISKER

Related tracks